Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
Installing the cooker
The kitchen area should be dry and aired and equipped with efficientventillation.Wheninstalling
the cooker, easy access to all control elements should be ensured.
This is a Y–type design built–in cooker, which means that its back wall and one side wall can be
placed next to a high piece of furniture or a wall. Coating or veneer used on fittedfurniture must
be applied with a heat–resistant adhesive (100°C). This prevents surface deformation or detach-
ment of the coating.
Hoods should be installed according to the manufacturer's instructions.
1 Assembly of ceramic hob with frame and brackets:
make an opening with the dimensions given in the diagram for the hob to be mounted on the
worktop;
Check seal for perfect fitandoveralcover.Lower the ceramic hob into place andalign correctly.
Tithten bracket against the underside of the worktop.
Using a standart screwdriver, tighten the tension clamps evenly starting at the centre and moving
diagonall, until the built-in rim is tight on the worktop.
139
120
1-worktop
2-screw
3-bracket
4-ceramic hob
5-hob seal
6-silikon
560
139
120
7
5
4
1
2
3
6
4
1
Publicidad
Tabla de contenido
