Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
pounds contain chemicals which may be harmful. Rinse with water after expo-
sure and wipe dry with a clean cloth.
Painted surfaces should be cleaned with warm water and mild detergent only.
OPERATION
Controls
The light switch turns the halogen lights on
and off.
The blower on / off switch turns the blower on
to the running speed set by the blower speed
control. The blower must be turned on and off
using this switch.
The blower speed control changes the run-
ning speed of the blower. It is infinitely adjustable
from low to high speed.
The pilot lamp lights up whenever the blower
is on.
HALOGEN BULBS
This range hood requires two or four halogen
bulbs (Type 12V, 20W).
ALWAYS SWITCH OFF THE ELECTRICITY
SUPPLY BEFORE CARRYING OUT ANY
OPERATIONS ON THE APPLIANCE.
To change bulbs:
1. Slacken the ring nut in an anticlockwise
direction.
2. Remove the bulb by pulling sideward (Do
not rotate). CAUTION: BULB MAY BE HOT!
3. Replace with a bulb of the same type.
LIGHT
SWITCH
- 6 -
BLOWER
SPEED
CONTROL
BLOWER
ON / OFF
SWITCH
PILOT
LAMP
BULB
RING NUT
Publicidad
Tabla de contenido
