List Of Parts - Cosatto MOOVA Guía De Instrucciones

•
If the harness/vehicle belt becomes cut or frayed, replace it before travelling.
•
If the car has been left in the sun for a long time, check the seat cover and make sure it is not
too hot before placing the child in the child car seat.
•
Security is only guaranteed if the child car seat is fitted in accordance with these instructions.
•
Failure to comply with the above instructions will automatically void the warranty and exempt
Cosatto from any liability.
notice:
1 This is a "Universal" child restraint .It is approved to Regulation No.44,04 series of amendments,
for general use in vehicles and it will fit most, but not all, car seats.
2 A correct fit is likely if the vehicle manufacturer has declared in the vehicle handbook that the
vehicle is capable of accepting a "Universal" child restraint for this age group.
3 This child restraint has been classified as "Universal" under more stringent conditions as those
which applied to earlier designs which do not carry this notice.
4 This child restraint is only suitable if the vehicle is fitted with a type approved lap/3 point/static/
with retractor safety belt, in compliance with standard UN / ECE Regulation No.16 or other
equivalent standards.
5 lf in doubt, consult either the child restraint manufacturer or retailer.
operation:

1 - list of parts

Your car seat is supplied in one carton and contains:
1. Seat cover
2. Upper seat liner
3. Lower seat liner
4. Chest pad x2
2 - where to position the car seat
WARNING: Your child car seat can only be installed forward facing using a three point lap and
diagonal belt in the front or rear passenger seats of the vehicle.
Under no circumstances use a lap strap to restrain the seat.
The child car seat must always face forwards.
The child car seat must be in the upright position for installation. See Step 3 for adjusting the seat
position.
3 - reclining the child car seat
The child car seat has a choice of three recline positions for your child's comfort. It can be used in
either a sleeping (a), reclined (b) or upright (c) position. The child car seat must be in the upright
position (c) when fitting to the vehicle.
Squeeze the recline handle (arrowed) then slide the base into the required position. Let go of the
recline handle and make sure that the child car seat has locked into place.
IMPORTANT
Each time you adjust the child car seat, check that it is still secure, the back rest of the
child car seat rests on the vehicles seat and that the seat belt is tight. If there is any
slack in the vehicle seat belt then retighten it before starting your journey.
4 - installation of the child car seat
This child car seat has been approved for mass group 1 which is suitable for transportation in cars
of children from 9 kg (approximately 9 months old) up to 18 kg (approximately 4 years old).
Place the child car seat in the forward facing position on the car seat.
Pull the vehicle seat belt and thread the diagonal and lap seat belt through the space behind the
child car seat (a) as shown.
5. Safety harness
6. Crotch cover
7. Adjustment strap
8. Recline handle
9. Base
10. Belt clip