Maxon T-330 Manual Del Usuario página 10

NOTE: Disconnect camera and sensor (if
equipped) harness from vehicle before
removing tailgate.
NOTE: If tie down hooks are welded into body of
truck, they do not need to be removed.
1. Unbolt tailgate, tailgate supports and
tie-down hooks from pickup bed (FIG.
10-1). Save the fasteners.
NOTE: The bumper and bumper mounting brackets
cannot be remounted after Liftgate is installed.
2. Unbolt and remove the rear bumper
(FIG. 10-2).
LIFT CORPORATION Sht. 10 of 58 DSG#
PREPARE TRUCK
M-14-25
Rev. E Date: 08/13/19
TIE DOWN
HOOKS
REMOVING TAILGATE
AND TIE DOWN HOOKS
FIG. 10-1
BUMPER
REMOVING BUMPER
FIG. 10-2
TAILGATE