Asus T2-PE1 Manual Del Usuario página 8

Replacing the cover Replacing the cover Replacing the cover Replacing the cover Replacing the cover
B B B B B
A A A A A
A A A A A
1. Fit the cover tabs with the
chassis rail and the front panel
tabs (A), then lower the rear
edge of the cover as shown
(B).
Selecting the voltage
The PSU has a 115 V/230 V voltage selector
switch located beside the power connector. Use
this switch to select the appropriate system
input voltage according to the voltage supply in
your area.
N O T E . N O T E . The voltage selector is set to N O T E .
N O T E . N O T E .
230 V by default.
If the voltage supply in your area is 100-127 V,
set the switch to 115 V. If the voltage supply in
your area is 200-240 V, set the switch to 230 V.
W A R N I N G ! W A R N I N G ! W A R N I N G ! Setting the switch to 115 V in a 230 V environment will W A R N I N G ! W A R N I N G !
seriously damage the system!
v i i i v i i i
v i i i v i i i v i i i
B B B B B
2. Secure the cover with three
screws.