Specifications - Troy-Bilt TB-50 Manual Del Operador

MOTOR WILL NOT START
C A U S E
Unit is unplugged
Overload protection switch has popped
CUTTING ATTACHMENT WILL NOT ADVANCE LINE
C A U S E
Cutting attachment bound with grass
Cutting attachment out of line
Inner reel bound up
Cutting head dirty
Line welded
Line twisted when refilled
Not enough line is exposed
CUTTING LINE ADVANCES UNCONTROLLABLY
C A U SE
Oil, cleaner or lubricant in cutting head
If further assistance is required, contact your authorized service dealer.
MOTOR
Motor type...........................................................................................................................................A.C.,120 Volts Electric
Operating RPM............................................................................................................................................. up to 7,400 rpm
On/Off Switch ............................................................................................................................................................. Trigger
Amperage................................................................................................................................................................ 4.7 amps
DRIVE SHAFT AND CUTTING HEAD
Drive Shaft Housing .............................................................................................................................................. Steel Tube
Unit Weight (With cutting attachment, cutting attachment shield and D-handle) .............................................9 lbs. (4.1 kg)
Cutting Mechanism ....................................................................................................................................... Bump Head™
Line Spool Diameter .................................................................................................................................3 inches (76.2 mm)
Trimming Line Diameter ........................................................................................................................... 0.065 in (1.65 mm)
Cutting Path Diameter.................................................................................................................................... 15 in (381 mm)
TROUBLESHOOTING
Check cord to make sure it is still plugged into an electrical outlet
Reset overload protection switch
Stop the unit and clean cutting attachment
Refill with new line
Replace the inner reel
Clean inner reel and outer spool
Disassemble, remove the welded section and rewind
Disassemble and rewind the line
Push the bump knob and pull out line until 4 inches (102 mm) of line
is outside of the cutting attachment
Clean and thoroughly dry the cutting head

SPECIFICATIONS

A C T I O N
A C T I O N
A C T I O N
13