Allen-Bradley 931U-C9A2C-OP Instrucciones De Operación página 9

Attenuator switch
For input voltages above 1 V.
1. Push in the lugs marked A & B below.
2. Pull the electronics forward gently to reveal the attenuator
switches.
3. Set the switches to the position required.
4. Recalibrate the inputs (see over).
Bit
1 V
10 V
A
Attenuator switch location and front panel locating lugs A & B.
1 2
On Off
Off On
3 4
On Off
Off Off
B
9