Chapter Iii Operation Guide - SATA AE1022H Manual Del Uso

Chapter III Operation Guide

3.1 Do not use the machine until you have read and understood the entire instructions and the warnings therein. Before the operation,
release the air from the tire and remove all leads from the wheel. The operation of the tire changer includes the following parts: a) tire
leaning; b) tire dismounting; c) tire mounting.
3.2 It is suggested to equip a pressure regulator for the tire changer.
3.3 Tire leaning
- Be extremely careful in the tire leaning. During rapid and forceful movement upon being driven by the tire leaning pedal, the tire leaning
arm will cause danger and crushing to everything in its moving area.
- Check whether the air is released from the tire; if not, empty the tire. Close the crankset claw thoroughly.
- If the claw is in an open position during tire leaning, it will be extremely dangerous to the operator's hands. Never touch the tire wall with
the hands during tire leaning.
62
AE1022H/AE1022H-3
中文
EN
- Place the wheel on the tire leaning rubber on the right side
of the tire dismounting chassis. Place the tire leaning shovel
against the tire opening about 1 cm away from the rim. Note that
the tire leaning shovel is placed on the top of the tire instead of
the rim.
- Step on the pedal and move the tire leaning shovel. When the
tire leaning shovel reaches the end of its operation route or
breaks the tire opening, loosen the pedal and gently rotate the
tire until the tire is completely removed from the rim.
DE RU KO PT JA ES