T&S B-0114-01 La Instalación Y Las Instrucciones De Mantenimiento página 5

Instructions For Repair Kits
For 010180 Pre-Rinse Assembly
Repair:
1. Using retaining ring pliers, remove
and discard no.12 from each knuckle
on no.3.
2. Slide Knuckle 'B' off shaft. Remove
no.11 and discard, then clean parts and
inspect for damage. If deep scoring
exists, parts must be replaced.
3. Apply thin coat of no.13 to shaft.
Assemble new no.11 onto shaft and
apply a coat of no.13 to no.11.
4. Replace Knuckles and assemble new
no.12.
5. Reassemble unit and check for leaks.
Servicing:
Riser Assembly
1. Loosen the two screws on the B-0109 Wall Bracket Clamp.
2. Unscrew no.9 from no.3. Disassemble no.5 from no.6.
3. Loosen no.8 on no.4. Carefully slide components from no.5.
4. Inspect no.5 for damage. Inspect the spring for cracks. Replace if necessary.
Apply no.13 to no.11 and reassemble.
5. Reassemble no.5 into no.6 and tighten with a wrench.
6. Tighten clamp screws on B-0109 Wall Bracket.
7. Connect water supply lines and check for leaks.
Knuckle
'A'
11
12
13
5
Knuckle
'B'