KALLISTA P73037 Guia De Instalacion página 4

Hanger
Bolts
Mark
anchoring
holes.
Apply
adhesive
Pedestal and Lavatory Placement
gaskets.
2. Install the Lavatory
Drill 1/4" mounting holes at the marked locations on the finished
wall.
NOTE: You can also use other fastening devices of sufficient size
and strength.
Install hanger bolts in the wall and floor so they extend 1-3/8"
(3.5 cm) beyond the finished wall.
Install the faucet and drain to the lavatory according to the
manufacturer's instructions.
Position the pedestal on the floor.
Carefully set the lavatory on the pedestal so the hanger bolts
extend through the lavatory anchoring holes.
CAUTION: Risk of product damage. Do not overtighten the cap
nuts. Overtightening may damage the product.
Install the washers and cap nuts to the hanger bolts. Level the
lavatory, and carefully tighten the cap nuts until snug.
Connect and tighten the trap to the drain. Complete the water
supply connections to the faucet according to the instructions
packed with the faucet.
Apply silicone sealant around the pedestal foot.
1036496-2-A
Install faucet
and drain.
Finished Pedestal
Wall
4
Washer
Cap Nut
Kallista