Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
STEP 1:
TIGHTEN ALL FITTINGS
Fittings can loosen in transit.
Use a wrench to tighten all hose
connections.
STEP 2: INJECT GREASE
INTO GUN MANIFOLD
The gun must be coated inside with
grease before first use.
With the valves closed, place the
gun over an empty bucket. Put the
grease gun on the fitting, push and
squeeze grease into the manifold.
Repeat with both grease fittings.
STEP 3: INSTALL
OLYBOND500 BOXES
Extend spout on Part 1 & Part 2 boxes.
Operating Instructions
Open window on each box.
Invert boxes and place in correct
trays, aligning windows with open
slots at front of each tray.
Grease connectors using grease gun
and finger, then connect spouts to
gravity hoses. Remove any air from
gravity hoses by squeezing and push-
ing air into box.
WARNING
Connector colors
Part 1: Black to Black
Part 2: Gray to Gray
O M G R O O F I N G P R O D U C T S
must match!
8 0 0 . 6 3 3 . 3 8 0 0
W W W . O L Y F A S T . C O M
4
STEP 4: CHECK POWER
SPECS, PLUG IN CART
Never run PaceCart 2 with low-
voltage power or you risk severe
damage to the motor!
The PaceCart 2 requires power in
the range of 110 to 125 volts, 15 amp.
Before beginning, check your power
source to be sure you are not compet-
ing with other equipment. Using an
overloaded line or an extension cord
longer than 100 feet will diminish your
power. If the machine stops operating
and begins to hum, turn it off immedi-
ately and check your power source.
STEP 5: PURGE GUN
TO PREPARE IT FOR USE
The gun must be purged by running
OlyBond500 material through it before
attaching mix tip.
With valves open and the gun over a
bucket, turn on the PaceCart 2 at the
power switch. For new PaceCart 2
equipment, leave valves open and let
material run for 1 minute after it starts
to flow to purge packing oil from
pumps. For each subsequent use, let
material flow for 30 seconds. There
should be equal streams of Part 1 and
Publicidad
Capítulos
Tabla de contenido
