Preparing Your Device - Veridian TENS Manual Del Usuario

PREPARING YOUR DEVICE

It is necessary to prepare and assemble your device prior to treatment.
NOTE: Save the large plastic film for storage after treat-
ment to protect the gel pads from dirt and debris.
1. Peel off the one side of the blue plastic
from the gel pads.
2. The gel pads are applied to the back of
the TENS Control Unit along the curved
electrode ridges.
3. While the device is OFF (the GREEN light
is NOT illuminated), carefully align the gel
pads on the back side as shown and press
firmly to ensure the pads are completely
adhered to the electrode ridges.
4. Carefully remove the plastic film from the
electrode pads.
5. You are ready to apply the pad to the
affected treatment area.
Do not turn the power ON until the
device is in place on the user's skin as
indicated in the 'Instructions for Use'
section of this manual.
ENGLISH • 15