Heath Zenith 7582 Manual Del Usuario página 7

4. Set the push button to work with the chime base.
Push Button (3A):
• Set push button switch 1 to ON (see Figure 7).
5. Sync the push button and chime base (see Figure 8).
• Press and release the "SYNC" button on the chime base.
Press the push button within 30 seconds.
• The chime base will play a "Beep-Beep" to indicate the push
button is synced.
• Press and release the push button to verify the chime and
push button are synced (see Figure 9).
6. Temporarily position chime base and push button where you
want them mounted and press the push button. Note: Do not
permanently mount the push button or chime base until you
are sure they are working properly. If chime does not sound,
see Wireless Troubleshooting (see page 11).
7. Remove batteries.
8. Mount chime base to wall using screws and anchors provided
(see Mount Chime Base, page 8).
9. After mounting chime base to wall, install batteries.
10. Select front door tune (see Tune Setting, page 9).
11. Turn volume control knob on chime base to adjust volume (see
Figure 10).
12. Press chime cover onto chime base.
Helpful Videos – www.hzsupport.com
ON
3A
1 2
Figure 7
SYNC – PRESS
AND RELEASE.
RESET – HOLD
10 SECONDS.
TUNE – HOLD
FRONT TRANS REAR
1 SECOND.
Figure 9
-7-
SYNC – PRESS
AND RELEASE.
RESET – HOLD
10 SECONDS.
TUNE – HOLD
FRONT TR
1 SECOND.
0
30
Figure 8
SYNC – PRESS
AND RELEASE.
RESET – HOLD
10 SECONDS.
TUNE – HOLD
FRONT TRANS R
1 SECOND.
Figure 10
Helpful Answers – 1-800-858-8501