Honeywell RLV210A Manual Del Propietário página 2

Hg
N O M E R C U RY
Specifications
Temperature Setting Range: 5°C to 27°C (41°F to 80°F)
Operating Temperature: 0°C to 50°C (32°F to 120°F) non-condensing
Storage Temperature: -20°C to 50°C (-4°F to 120°F)
Supply: 120 VAC, 50/60Hz; 208 VAC, 50/60Hz; 240 VAC, 50/60Hz
Minimum Load: 1.25 A (150 W); 1.25 A (300 W)
Maximum Load: 12.5 A (1500 W); 12.5 A (3000 W)
Installation
WARNING Electrical Shock Hazard.
This thermostat is a line voltage control (120–240 Volts). Do not install it if
you are not completely familiar with house wiring. If handled improperly,
there is risk of electric shock hazard, which may cause serious injury or
death.
1. Connect the thermostat as shown on page 3.
2. Remove the thermostat faceplate cover by prying it from the top or bottom
with your fingers.
3. Install the thermostat onto the electrical box using supplied screws.
4. Place the faceplate cover back.
5. Apply power to the heating system.
ATTENTION: MERCURY RECYCLING NOTICE
This product does not contain mercury. However,
this product may replace a product that contains
mercury. Mercury and products containing
mercury should not be discarded in household
trash.
For more information on how and where to
properly recycle a thermostat containing
mercury in the United States, please refer to the
Thermostat Recycling Corporation at
www.thermostat-recycle.org.
For mercury thermostat recycling in Canada,
please refer to Switch the Stat at
www.switchthestat.ca
2