Zoeller AquaNot 508 Active Instrucciones De Instalación página 5

FIGURE 1
IMPORTANT
FIGURE 2
®
AQUANOT ACTIVE
CONTROLLER
CHARGER
OUTLET
®
Z CONTROL
GATEWAY
HIGH WATER
FLOAT SWITCH
LOW WATER CUT-OUT
FLOAT SWITCH
(*OPTIONAL)
IMPORTANT: "OFF" LEVEL
OF FLOAT ASSEMBLY
MUST BE HIGHER THAN
1" (2.5 cm)
DC BACKUP PUMP
MIN.
1 1/2" INLINE
CHECK VALVE
*IF YOU PREFER TO USE THE LOW WATER FLOAT, THE SUPPLIED JUMPER
CAN BE REMOVED AND THE LOW WATER FLOAT INSTALLED IN ITS PLACE.
®
AQUANOT ACTIVE
CONTROLLER
CHARGER
OUTLET
®
Z CONTROL
GATEWAY
HIGH WATER
FLOAT SWITCH
LOW WATER CUT-OUT
FLOAT SWITCH
(*OPTIONAL)
IMPORTANT: "OFF" LEVEL MUST
BE SET ABOVE PRIMARY PUMP INLET.
*IF YOU PREFER TO USE THE LOW WATER FLOAT, THE SUPPLIED JUMPER
CAN BE REMOVED AND THE LOW WATER FLOAT INSTALLED IN ITS PLACE.
To minimize risk of air lock, intake of DC pump must be set above intake of primary pump.
BATTERY BOX
OPERATIONAL
FLOAT SWITCH
SHOWN FOR CLARITY
© Copyright 2016 Zoeller
SHOWN FOR CLARITY
FIGURE 3
AQUANOT ACTIVE
CONTROLLER
CHARGER
OUTLET
®
Z CONTROL
GATEWAY
90° ELBOW & TEE SHOWN.
45° ELBOW & WYE CAN
BE USED AS WELL.
DO NOT USE DWV FITTINGS.
HIGH WATER
FLOAT SWITCH
LOW WATER CUT-OUT
FLOAT SWITCH
(*OPTIONAL)
IMPORTANT: "OFF" LEVEL
MUST BE SET ABOVE
PRIMARY PUMP INLET.
*IF YOU PREFER TO USE THE LOW WATER FLOAT, THE SUPPLIED JUMPER
CAN BE REMOVED AND THE LOW WATER FLOAT INSTALLED IN ITS PLACE.
SK3052
Co. All rights reserved.
®
5
BATTERY BOX
OPERATIONAL
FLOAT SWITCH
1 1/2" INLINE
CHECK VALVE
®
SHOWN FOR CLARITY
SK3051
BATTERY BOX
OPERATIONAL
FLOAT SWITCH
1 1/2" INLINE
CHECK VALVE
SK3044