Remote Controlling the
Socket with FRITZ!Fon
With the latest FRITZ!Fon cordless DECT
telephones from AVM, you can remote
control the socket of your FRITZ!DECT 200
(by switching it on and off ).
1. Press the "Menu" key on FRITZ!Fon.
2. Select "Home Network" and then
press "OK".
3. Select "Smart Home" and then press
"OK".
4. Under "FRITZ! Actuators", select a
FRITZDECT device and press "off " or
"on" to change its status.
Log Off
If you would like to register FRITZ!DECT
200 with another FRITZ!Box, de-register it
from the current FRITZ!Box fi rst:
1. Hold the "DECT" button down for at
least 6 seconds.
2. FRITZ!DECT 200 is de-registered from
the FRITZ!Box.
After a brief delay the LED "DECT" begins
fl ashing. Now you can register FRITZ!DECT
with another FRITZ!Box.
Removing FRITZ!DECT 200
from the power outlet does not
de-register it from the FRITZ!Box.
12
Help in Case of Errors
No connection with the base station
The "DECT" LED fl ashes briefl y at regular
intervals. FRITZ!DECT 200 does not have a
wireless connection to the FRITZ!Box.
1. Insert the FRITZ!DECT in an outlet near
your FRITZ!Box.
2. When the "DECT" LED lights up, the fi rst
outlet is located outside the range of the
FRITZ!Box, or the wireless connection
is faulty.
Typical sources of interference
include (multiple) closed doors and
zones with high humidity.
If „DECT" continues fl ashing, FRITZ!DECT
200 is not registered with the FRITZ!Box.
Register FRITZ!DECT 200 again.
Integrated socket switched off
The "On/Off " LED fl ashes briefl y at regular
intervals and the connected electrical
device does not work. The integrated socket
is off .
Remove the electrical device from the
FRITZ!DECT 200 socket.
Press the "On/Off " button. The integrat-
ed socket is switched back on.
The "On/Off " LED lights up.
Do no subject FRITZ!DECT 200 to a
load higher than its limit of 2300
watts. The connected devices can
take a permanent current of no
more than 10 A (resistive load).
Insert the electrical device back into the
integrated socket.
13