After Cleaning Care - Bissell CROSSWAVE CORDLESS MAX 2590 Serie Manual Del Usuario

After Cleaning Care

Go to support.BISSELL.com for a full list of how-to videos.
1.
Place the machine on the
3-in-1 Docking Station. Make
sure the solution in the Clean
Water Tank reaches the Clean
Out Cycle line. If it does not, fill
tank with water to that line.
4.
Once the cycle is complete,
remove the Brush Roll by
grabbing the Brush Roll
window and pulling up. Pull
the Brush Roll tab to remove
and put the brush in the drying
tray. The brush and window
can be hand washed.
WARNING
electrical outlet before performing maintenance or troubleshooting on the dock.
2.
Make sure the water in the
Dirty Water Tank is not over
the Full line. If it is, empty
the tank and replace it before
running the Clean Out Cycle.
5.
Remove the machine from
the dock and wipe out the tray.
Do NOT rinse under faucet.
This keeps water out of the
charging plug.
To reduce the risk of fire, electric shock or injury, turn power OFF and disconnect plug from
3.
Push the Clean Out Cycle
Button to start the 40-second
cycle. Note: If the battery
runs out the Clean Out Cycle
cannot run until your machine
is docked for 30 seconds.
6.
Empty the Dirty Water
Tank. To remove, press the
button on the top of the tank,
grab the front handle and pull
tank out.
CONTINUED ON NEXT PAGE
BISSELL.com 9