Torin BIG RED T32100 Manual Del Propietário página 5

OPERATOR SHOULD ALWAYS
1. Be familiar with Engine Leveler operating controls, procedures and warnings.
2. Make sure all connections to load are tight and secure.
3. Maintain firm footing when operating Engine Leveler.
4. Make sure that load is free to move and will clear all obstructions.
3. Take up slack carefully, check load balance, lift a few inches and check load holding action before
continuing.
4. Avoid swinging of load.
5. Make sure that all persons stay clear of the suspended load.
6. Warn personnel of an approaching load.
7. Protect load chain from weld spatter or other damaging contaminants.
8. Promptly report to your supervisor or repair any malfunction, unusual performance, or damage of the
Engine Leveler.
9. Inspect Engine Leveler regularly, replace damaged or worn parts, and keep appropriate records of
maintenance.
OPERATOR SHOULD
1. Never lift more than rated load.
2. Never use damaged Engine Leveler or Engine Leveler that is not working correctly.
3. Never use the Engine Leveler with twisted, kinked, damaged or worn chain.
4. Never lift a load if any binding prevents equal loading on all supporting chains
5. Never allow the operators attention to be diverted from operating the Engine Leveler.
6. Never use Engine Leveler to lift, support or transport people.
7. NEVER LIFT LOADS OVER PEOPLEI
8. Never leave a suspended load unattended.
9. Never allow sharp contact between sling and obstructions.
10. Never allow the chain or link to be used a as ground for welding.
11. Never allow the chain or link to be touched by a live welding electrode.
10. Never attempt to lengthen the load chain or repair damaged chain.
11. Never wire, clamp or otherwise disable the lift control to function by any means other than by using the
operator's hand.
WARNING: USE EXTREME CAUTION WHEN TURNING HANDLE. THE HANDLE MAY TURN RAPIDLY.
FAILURE TO HEED THESE WARNINGS COULD CAUSE SERIOUS INJURY OR DEATH.
ADDITIONAL OPERATING INSTRUCTIONS
To remove an auto or truck engine with transmission intact, first uncouple the transmission and remove motor
mount bolts. With the Engine Leveler hooked to an overhead hoist above the engine, attach the L-shape
connections at the end of the four (4) chains (choose one of two holes provided) to the engine head bolts -
two at front, both sides, and two at rear, both sides. Using the engine hoist, take up slack in chain carefully. Lift
a few inches and check load balance. To reach the desired angle for load balance, adjust the position of the
movable fulcrum in the beam by turning the handle or the 1" hex adjusting nut at end of the worm shaft with a
ratchet wrench. Then carefully lift out the engine and transmission. By turning the handle one direction or the
other, the suspended engine and transmission can then be tipped only enough to remove. Reverse the above
steps to reinstall repaired engine transmission. For this and other types of loads, make sure all connections
are tight and secure before operating the hoist.
5