Using A Hand Held Edger; Adjusting The Cutting Depth - Shindaiwa LE242 Manual Del Propietario - Operador

Using a Hand-held Edger
Guidelines for Operating the Edger
 Before edging, make sure the area is
soft enough so the blade does not bog
down. If necessary, water the area before
edging.
 Remove debris and other obstacles that
could be thrown by the rotating blade.
 Plan your work so the edger blade is
always on your right-hand side.
 Begin each pass by positioning the unit
over the work, and with the engine run-
ning at about half-throttle. Slowly lower
the blade to the ground while applying
full throttle. See Figure 16.
 Do not move the edger into the work so
fast that the engine or blade bogs down.
CAUTION!
Low-speed edging can lead to prema-
ture clutch failure.
 Do not pull the unit backward over the
ground with the engine running. Doing
so will tend to bury the blade.
Regular and frequent use of the edger
will make a neater lawn, and a frequently
trimmed edge will be easier to maintain.

Adjusting the Cutting Depth

Figure17
10
Figure 16
26021
Guide Wheel
Adjusting knob
Guide Wheel
The numbers are for
reference only; they do
NOT refer to depth in
Figure 17a
 Wear eye protection, long pants,
and boots when operating this
machine!
 Whenever you strike a hard
object with the blade, always stop
the edger and carefully inspect
the blade for damage. NEVER
OPERATE THE EDGER WITH A
DAMAGED BLADE!
The edger's depth of cut is controlled by a
combination of operator height, blade wear,
and the positioning of the edger's guide
wheel.
To adjust blade height:
1. Loosen the guide wheel adjusting knob.
See Figure 17.
. Raise or lower the guide wheel to the
desired setting. See Figure 17a.
. Tighten the guide wheel adjusting knob
firmly . See Figure 17.
Never adjust the guide wheel while the
engine is running.
Guide wheel adjustment is also required to
compensate for blade wear.
inches
ment edger blades.
WARNING!
WARNING!
NOTE
WARNING!
Use only Shindaiwa replace-