List Of Parts; Fitting The Raincover - Cosatto YO Manual Del Usuario

1 list of parts

Your pushchair is supplied in one carton and
contains:
1. Pushchair (basket attached)
2. Rear wheels x 2
3. Front Wheel x 2
2 attaching the wheels
To attach the rear wheels, push in the small button on the wheel housing and insert the wheel
stem into the wheel housing until it clicks in place and release the button. Check the wheel is
securely attached then repeat the above process on the opposite side. To remove the wheels push
in the small button on the wheel housing and detach the wheel.
Attach the front wheels by pushing the wheel stem into the wheel housing till it locks in place.
Check the wheel is securely attached then repeat the above process for the remaining wheel. To
remove the wheels push in the release button on the wheel housing and detach the wheel.
a - Release button
3 opening the buggy
To open the buggy, first release the folding lock (a) then pull up on the handles pushing down on
the foot pedal (a) as you do until the buggy is fully erect.
WARNING: Ensure that all locking devices are engaged before use.
4 attaching the basket
Your shopping basket comes partially attached and only needs the final attachment making at the
front of the buggy. Wrap the strap of the basket around the buggy crossbar so that it is located
between the small stud and the wheel and secure with the press stud. Maximum load 3kg (6.6lb).
a - Press stud
5 fitting the hood
To attach the hood, slide the hood ends on to the two brackets located on the inside, either side of
the chassis. Finally secure the Velcro ® tabs either side of the hood to the seat unit.
To remove release the Velcro ® and slide the hood back off the two brackets.

6 fitting the raincover

Fit the rain cover over the seat and hood as shown, securing the raincover by inserting the straps
through the "D" rings located above the wheel as shown. Release if your child kicks the rain cover,
otherwise the rain cover may tear. Secure the back and sides using the Velcro ® tabs.
WARNING! Ensure adequate ventilation at all times and remove the rain cover whenever indoors or
in a warm environment.
7 using the footmuff
To fit the footmuff unfasten the harness and pass harness and 'D' rings through slots on the back
of the footmuff. To remove the footmuff reverse the above procedure.
8 using the brakes
To apply: Press down on the pedal on either of the rear wheels.
Check the brakes have engaged by trying to push and pull the stroller.
To release: Pull up on the pedal on either of the rear wheels.
a = On b = Off
9 using the swivel wheels
To lock the front wheels and prevent any swivelling, push up on the lock as shown and push the
buggy forwards until the wheels lock. To unlock the front wheels and allow swivelling, push down
on the lock.
4. Hood
5. Raincover + Bag
6. Shoulder pads
7. Footmuff