Noxon High Speed Cablecam Manual De Usuario página 14

English
Turning on the wireless controller:
1. Press and hold the center button until the screen turns on.
2. Rotate the center knob in any direction to complete the line on the screen.
Synchronization:
1. Synchronization between the High Speed Cablecam and the hand control is automatic.
2. Once turned on, the appearance of the EXT battery level indicator bar will mean that the connec-
tion between the controller and the cablecam has already been established.
NOTE: If the EXT battery indicator (1) we see a rectangle with a diagonal line inside it, it means that
there is no connection.
Battery charging:
1. Remove batteries from the High Speed Cablecam.
2. Connect the battery to the charger lipo batteries up to 6S Ev-Peak C1-XR
NOTE: The Ev-Peak C1-XR up to 6S lipo battery charger is not included in the package.
Charging the Wireless controller:
1. Connect the USB cable to the controller and to a USB charging port.
Checking charge status:
1. Disconnect the battery from the charger.
2. Connect the battery to the High Speed Cablecam.
3. Turn on the High Speed Cablecam and the hand control.
4. Check the EXT battery level on the hand control display.
Tips and Warnings:
1. The start of the movement is done smoothly, this can give a wrong impression about the real ac-
celeration capacity of the device. From 5Km / h the acceleration limit is canceled, being able to reach
very high speeds very quickly.
2. Never turn off the High Speed Cablecam by disconnecting the batteries; use the on / off button. If
you have disconnected the batteries, wait at least 5 minutes before reconnecting them.
Disclaimer:
Noxon is not responsible for damage caused by improper use or modifications made to the product.
Pág. 14