Multipoint Mode - Noxon High Speed Cablecam Manual De Usuario

English
Multipoint mode: It allows creating movement sequence with time control. The movement will be
single axis.
1. Enter the travel points by moving the apparatus and marking the positions with the control knob, or
entering them numerically in a table.
2. The points recorded by moving and marking the positions with the control knob will be reflected in
that same editable table, so it is also possible to correct or modify by hand
3. Set the times by editing the values in the table. The values will be the moment in which you want
the device to reach the indicated position and the time you want it to remain immobile.
Settings / Settings
• Brightness: Adjusts the screen brightness on a scale of 1 to 10.
• Delay Start: This is the amount of time that elapses between the press to start the programmed
movement and the actual start of the movement. It is configurable in steps of 5 seconds with a range
between 0 (canceling the delay) and 60 seconds.
• Remote Auto-Off: Activates the remote's auto-off after 10 minutes of inactivity.
• Controller Auto-Off: Activates the Compact Slider motion system auto-off after 10 minutes of inacti-
vity.
• LCD Auto-Off: Auto turn off the screen after 60 seconds of inactivity.
• Beep: Activates the playback of a beep just before the start of an automatic movement.
• RF Channel (Radio frequency channel selection): selecting a different channel allows the possibility
of working with two different devices in the same place.
• Info: Allows access to the screen where information about the firmware version of the remote con-
trol, the motion system and the serial number is displayed. It also enables activation of the firmware
update mode.
Pág. 19