Chapter Five Equipment Package - SATA AE5603 Manual Del Uso

AE5603
EN DE RU KO PT JA ES
equipment, it may cause overheat or burning.
6. Be sure to take power plug off when equipment is not used. Take plug off, Don't take plug off by mean of pulling cable.
Reel the cable on the equipment loosely in storage.
7. Power source require to be AC220V 50 HZ, power socket with Three terminals 10A is required.
8. Measuring camera, target plate and clamps are all precision parts, please handle gently in operation.
9. To keep best security and performance of computer system of aligner, please don't install other software optionally
Chapter Five Package
Four wheel aligner is precise measuring instrument. Both soft and hard package need to do well.
The detail as follows:
wrap single part well with EPE, and then pack it by tape or wrapping film to avoid the package loosing. after soft packed
well, Beam is suspended in the wooden case. The camera covers in both ends can not touch wooden case. Cabinet should
be fixed on the base of wooden case. Cut the foam block and insert the case. and then put well wrapped single parts into
the case and filler to avoid the parts moving inside. Put foam block upside and then close the cover. Pay attention to signs
of fragile,collision and rain avoidance.(Picture only for reference)
63
- 03 -