Connecting Electrical Appliances; Switching On The Vacuum Cleaner; Switch Position "I; Switch Position „Auto - MIRKA 412 Manual De Instrucciones

Mirka 412 / 415 / 415 M
english
4.1.3 Connecting electrical
appliances
4.2 Switching on the
vacuum cleaner

4.2.1 Switch position "I"

Mirka 415 M: The hose diameter
and the setting for the suction hose
diameter must be the same.
Hose
ø
ø27
ø32
ø36
ø50
4.2.2 Switch position „auto"
Mirka 415 M: The hose diameter
and the setting for the suction hose
diameter must be the same.
Hose
ø
ø27
ø32
ø36
ø50

4.2.3 Suction power control

4.3 Check volume flow
monitor (Mirka 415 M)
6
To comply with regulations, only ap-
proved dust producing tools should
be connected.
The maximum power consumption
of the connected power tool is stat-
ed in section 9.4 "Technical data".
Hose diameter
setting
ø27
ø32
ø36
ø50
Hose diameter
setting
ø27
ø32
ø36
ø50
Before picking up dust with maxi-
mum room concentration values:
1. Ensure that the electrical
appliance is switched off.
2. Connect the electrical appli-
ance to the appliance socket
on the control panel.
1. Turn the switch to position
„I".
The vacuum cleaner motor
starts.
Before switching the switch to posi-
tion „auto", ensure that the tool con-
nected to the appliance socket is
switched off.
1. Turn the switch to position
„auto". The vacuum cleaner
motor starts when the con-
nected appliance is switched
on.
2. When the power
switched off the vacuum clean-
er continues to run for a short
moment so that any dust in
the suction hose is conveyed
to the safety filter bag.
The motor speed and the suc-
tion power can be varied with
the suction power control. This
allows precise adaptation of the
suction power for different clean-
ing tasks.
1. Check that all the filters are
present and properly fitted.
2. When the motor is running,
hold the suction hose shut.
An acoustic warning sounds
after approx. 1 second.
tool is