Worx WA3769 Instrucciones De Uso página 5

with the charger or the electrode of the battery
pack. Otherwise, there will be short circuit or circuit
danger.
INSTALLATION AND
OPERATION
1. Insert charging stand into battery pack
Insert the charging stand into the charged battery
pack and force it into place.
2. Remove the charging stand
First, press the battery pack button, then drag the
charging stand to slide out.
Note: When not in use, the charging stand should
be removed from the battery pack.
3. Charging button on charging stand
The charging stand has an on/off button (1).
Connect the charging stand to the battery pack and
then connect the cell phone. You need to press the
charging button to charge. The LED power indicator
(2) lights up for five seconds and then goes out.
During charging, press the charging button to
show the remaining power of the battery pack the
Charging indicator. The indicator light will go out
after 5 seconds.
4. Charging
LED power indicator
When the charging stand is plugged into the battery
pack and the switch button (1) is pressed, the LED
power indicator (2) will illuminate,, showing the
battery pack's power status for 5 seconds.
The LED power indicator shows the remaining power
of the battery pack as follows:
Press the button, the indicator shows different status
according to the battery pack's power.
When the button is released, the indicator light will
be on for 5 seconds.
Status
Remaining 90%-100%
Remaining 70%-90%
Remaining 40%-70%
Remaining 10%-40%
Remaining electricity is less
than or equal to 10%.
Note: "
" stands for turning on the light. "
means flickering. " " means that the light is not
on.
Note: If the power is less than 10%, the charging
20V Cordless USB Charger Adapter
Capacity
"
stand will stop discharging. This means that the
battery pack needs to be charged.
5. USB charging port
The charging stand is equipped with two USB
charging ports (3), and the total output current is
2.1A.
Note: In order to prolong the service life of the
charging stand, please do not insert a cell phone
whose charging current exceeds the current shown
in the label on the charging stand. When charging
a cell phone, insert a USB plug into one of the
charging ports.
MAINTENANCE
There are no repairable parts in your charging stand.
For adjustment, repair or maintenance, please
leave it to the professional. Do not try to repair the
charging stand yourself.
Your charging stand does not need to be lubricated
or otherwise maintained. Don't clean the charger
with water or chemical cleaning agent, just wipe it
with a dry cloth. Store in a dry environment.
FCC Part 15
Supplier's Declaration of Conformity
Product Description: 20V Cordless USB
Charger Adapter
Model Number: WA3769
Trade Name: WORX
This device complies with part 15 of the FCC
Rules.
Operation is subject to the following two
conditions:
(1) This device may not cause harmful
interference, and
(2) This device must accept any interference
received, including interference that may
cause undesired operation.
Responsible Party :
Positec USA, Inc.
10130 Perimeter Parkway, Charlotte, NC 28216 USA
Tel.: (704) 599-3711
Fax: (704) 599-6390
5
EN