Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
PREPARATION
Place the product on a firm, level surface and plug into a 120V 60Hz power outlet. Only operate product in upright
position.
OPERATION INSTRUCTIONS
Completely uncoil the cord and plug heater directly into a 110~120 Volt grounded AC wall outlet. Be sure the plug fits
tightly. A loose fit will cause overheating and damage the plug. Plug and cord may feel warm during normal usage.
NOTE: This unit in not equiped with a thermostat, it will run continously until powered off.
This product can be used YEAR ROUND
Rotate the heat/fan control knob to desired setting Fan or Heat (Figure 1)
To select Fan Mode, turn the switch clockwise to the fan mode marked in BLUE, select "LO" or "HI" according to your
needs.
To select Heat Mode, turn the switch clockwise to the fan mode marked in select "LO" (750W) or "HI" (1500W)
according to your needs.
High Heat mode
Low Heat mode
OFF
Figure-1
~ 5 ~
Low Fan mode
High Fan mode
Publicidad
Tabla de contenido
