Cleaning The Soleplate - T-Fal FV22 Serie Manual Del Usuario

• Gently shake the iron over the sink until all of the water (along with impurities) flows out through the soleplate.
• At the end of the Self-Cleaning process, replace the anti-scale valve, set the iron on its heel and heat for 2
minutes.
Never use abrasive or aggressive
products.
If there is a problem
PROBLEM
Water drips from the holes
of the soleplate
Brown streaks come through
the holes of the soleplate
and stain the fabric.
The soleplate is dirty or brown
and is staining the fabric.
There is little or no steam.
The soleplate is scratched or
damaged.
Steam or water comes from
the iron as you finish filling the
tank.
The spray button does not
spray water.
For all other problems or questions, please contact our Consumer Service Department at 1-800-395-8325 or visit us at
www.t-falusa.com. Or in Canada at 1-800-418-3325 or visit our website at www.t-fal.ca. You may also contact an approved
Service Center, please visit our website for their contact information.
• Unplug the iron. While the soleplate is slightly warm, wipe it with a soft
cloth.
POSSIBLE CAUSE
The chosen temperature is too low and
does not allow for the formation of steam.
You are using the steam feature before the
iron reaches a high enough temperature.
You are pushing the Burst of Steam button
repeatedly at too short intervals.
There is too much steam.
You have stored the iron horizontally, wi-
thout emptying it and without setting it
to .
You are using chemical descaling agents.
You are not using the right type of water.
Fabric fibers have accumulated in the holes
of the soleplate and are burning.
Your fabric has not been rinsed
sufficiently or you have ironed a new gar-
ment before washing it.
The temperature is set too high.
You are using starch.
The water tank is empty.
The anti-scale valve is dirty.
Your iron has a build-up of scale.
Your iron has been used dry for too long.
You have used your iron on an abrasive sur-
face or it has been misused.
The steam control lever is not set to the
position.
The water level in the tank is too low.
SOLUTION
Position the temperature control dial in the steam range
(from •• to MAX).
Wait until the temperature light goes out.
After using the Burst of Steam, wait a few seconds before
pressing the button again.
Move the steam control lever to a lower setting.
See the section "Storing your iron".
Do not add any descaling agents to the water tank.
Do a self cleaning and consult the chapter "What type of
water should be used?".
Do a self cleaning and wipe the soleplate with a damp
sponge. Vacuum the holes of the soleplate from time to
time.
Make sure that laundered clothes are rinsed thoroughly
to remove any soap deposits. Launder new washable
clothing before ironing.
Clean the soleplate with a damp sponge and lower the
temperature.
Clean the soleplate with a damp sponge. Always spray
starch onto the reverse side of the fabric to be ironed.
Fill it.
Clean the anti-scale valve.
Clean the anti-scale valve and do a self cleaning.
Do a self cleaning.
The T-fal iron has a Lifetime warranty on the soleplate
(valid in USA and CANADA only). Please contact our
consumer service department at 1-800-395-8325.
Set the steam control lever to
Fill the water tank.
8

Cleaning the soleplate

.