Pressure Regulator; Safety Valve; Air Outlet - MADER BM20-50 Manual De Instrucciones

--------------------------------------------------------------------------------------------------------------
OPERATION
The pressure in the tank is controlled by the action of the pressure switch located under the
pressure switch cover.
When the set maximum pressure is reached the pressure switch activates and the motor is
turned off. The pressure will then decrease as the air is used until the set minimum is
reached after which the pressure switch turns the motor on again.
The operator of the compressor should be well aware that during use of the compressor the
motor will cycle (start and stop) under the influence of the rising or falling pressure in the tank
and the motor will start without any warning.
The maximum and minimum pressures are factory set and should not be altered.
You can utilize either the direct outlet and/or the regulated outlet. The pressure of the
regulated outlet can be changed by turning the control knob. Rotate the knob clockwise to
increase pressure and anti-clockwise to decrease.
Turn on

Pressure regulator

Turn off

Safety valve

Air outlet

Tank gauge
Regulator gauge
Note: Output fittings may differ from those shown.