Cequent Performance Products 65065 Instrucciones De Instalación página 4

Note: Requires removal or trimming of Front air dam for hitch installation.
Obtain owner permission before trimming.
1. Remove tow hooks if present, keep for re-installment . Return
hardware to owners.
3. Recommend taping block (9) to tow hook-install forward fastener.
Install fasteners (10 & 5) through tow hook, then return tow hook to
original position in bumper slot and loosely tighten in place. Both sides.
See Figure 3.
©2015 Cequent™ Performance Products, Inc. -
Printed in Mexico
2. Use reverse pull wire procedure to install forward carriage bolt (1) and
spacer (2). See Figure 2. Leave pull wire attached.
4. Raise side bracket (Note: bracket specific to each side. See Figure 1) to
frame rail and under tow hook. Feed existing pull wire through hole and
secure with carriage bolt. Feed lock washer (3) over pull wire, using the
washer to hold the bolt in place remove the pull wires and attach the hex
nut(4). Hand tighten both sides
Sheet 4 of 15 65065NP 7-27-15 Rev. B