Stages cycling STAGES POWER SPM1 Guía De Usuario página 7

The Stages Power® device may be protected by USA or foreign patents or
patents pending.
This document may contain trademarks or registered trademarks of Stages
Cycling LLC as represented by the use of ™ and® respectively.
ANT+™ is a trademark of Dynastream Innovations Inc.
Bluetooth® is a registered trademark of Bluetooth SIG, Inc.
Apple®, iPhone®, iPad® are registered trademarks of Apple Inc.
Android™ is a trademark of Google Inc.
Garmin ® is a registered trademark of Garmin Corporation
Wahoo™ is a trademark of Wahoo Fitness LLC
Copyright ©Stages Cycling LLC, 2013
12
Stages Cycling™
Important Product Information
Contact Information:
Stages Cycling LLC
1732 NW Quimby
Suite 250
Portland, OR 97209
www.stagescycling.com
info@stagescycling.com
California Proposition 65
The enclosed hardware and its packaging contain chemicals the State of California has found to cause cancer, birth defects or
reproductive harm.
RoHS
Stages Cycling certi es that this product and its packaging are in compliance with European Union Directive 2011/65/EU on
the Restriction of the Use of Certain Hazardous Substances in Electrical and Electronics Equipment, commonly known as
RoHS.
FCC Rules Part 15
The enclosed hardware device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference and (2) it must accept any interference received, including interference
that may cause undesired operation.
FCC Compliance Statement:
This equipment has been tested and found to comply with limits for a Class B digital device, pursuant to Part 15 of the FCC
rules. These limits are designed to provide reasonable protection against harmful interference in residential installations. This
equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause interference to radio or television equipment reception,
which can be determined by turning the equipment o and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help
To assure continued compliance, any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment. (Example- use only shielded interface cables when
connecting to a computer or peripheral devices).
Caution! The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications
to this equipment. Such modi cations could void the users authority to operate the equipment.
IC Statement
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device. The device meets the exemption from the routine evaluation
limits in section 2.5 of RSS 103 and users can obtain Canadian information on RF exposure and compliance.
Le présent appareil est conforme_aux CNR_d'Industrie Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur
de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le
fonctionnement. Le dispositif rencontre l'exemption des limites_courantes d'évaluation dans la section 2.5 de RSS102 et les
utilisateurs peuvent obtenir l'information canadienne sur l'exposition et la conformité de rf.
Product Name: Stages Power™
Model Name: SPM1
FCC ID: PADWF105
IC ID: 10563A-WF0105
13