Knape & Vogt SBM Serie Instrucciones De Ensamblaje página 2

Parts Included
A. Waste Bin (1)
B. Wire Cage (1)
C. Sliding Base Assembly (1)
D. Handle (1)
E. Cage Locking Clip (1)
F. Mounting Screws (4)
A
B
C
Mounting
Straps
Sliding Members
D
E
Tools Required
• Phillips head screwdriver
• Drill with 1/16" (1.5mm) bit for
drilling pilot holes
• Pencil
Product Assemblies
BLSC9-1-20-R SBM9-1-20
BLSC10-1-35-R SBM10-1-35
SCB-9-1-20 SBM12-1-50
SCB-10-1-35 SBM15-1-20
SCB-12-1-50 SBM15-1-35
SCB-15-1-20
2700 Oak Industrial Drive NE , Grand Rapids, MI 49505 USA
800.253.1561 • 616.459.3311 • www.kv.com
Sliding Single Soft-Close Waste Bin
Inspect all parts and read all instructions prior to beginning assembly and installation.
1.
Place sliding base assembly on cabinet floor, in desired position. Position front mounting strap
against the back edge of the cabinet face frame. (If installing in a frameless cabinet, measure
1/2" to 3/4" back from front of cabinet opening, and align sliding base assembly parallel to cabinet
opening.) Close door to make sure the assembly will not hold cabinet door open. Also, check
to see if unit will clear the door opening when fully extended. Once position is determined, fasten
in place using four mounting screws provided and a Phillips head screwdriver.
Optional Step: Mark placement of mounting holes with a pencil, remove sliding
base assembly and drill pilot holes for fastening screws. Place sliding base
assembly back into position and fasten with the provided screws.
2.
Fully extend sliding members out of the cabinet. Place the slotted holes on the cage onto the tabs
on the left hand sliding member. (2A) Rest the cage on top of the clip retainers on the right hand
sliding member, but, DO NOT PUSH DOWN. Close unit so that the wire cage is completely inside of
the cabinet. Now, push down firmly on the right side of the wire cage, until it is fully seated
into the clip retainers. (2B)
3.
Install cage locking clip into right hand side only by placing the tabs on the top of the clip into
the openings in the slide. Then push the top and bottom of the clip until it snaps into place. (3)
4.
Clip handle onto front of cage. (4)
1
F
2B
Clip
Retainer
Clip Retainer
©2017 Knape & Vogt. All rights reserved. Made in USA. Knape & Vogt
2A
Tab
3
Pull Bottom
Push Top
Step 1
Push Bottom
Push Top until it snaps
Step 2
® reserves the right to change specifications without notice.
4
310402-E_0417