AVM FRITZ!Powerline 1000E Guía Rápida página 5

Optimizing the Data Rate
A powerline network is infl uenced by many factors. With the following steps you can
contribute to an optimal data rate in your powerline network:
 Avoid using multi-outlet strips.
 Insert powerline devices directly into wall outlets.
 If you have to multi-outlet strips, then ...
– use multi-strip outlets without surge protection.
– connect as few devices as possible to the multi-outlet strip.
– insert your powerline device in the fi rst socket, directly at the cable.
 If you cannot avoid using multi-outlet strips with surge protection, then the surge
protection should be located behind the powerline device.
 The data rate in a powerline network drops during a connection using multiple
phases if there are junction boxes along the path between your powerline devices,
if the connection has to pass through a ground fault circuit interrupter (GFCI),
dimmer or electronic control gear (ECG), or if power drills or vacuum cleaners are
used. Attempt to minimize these infl uences.
 The quality of your powerline network can also be managed and optimized using
the AVM FRITZ!Powerline software (see page 14).
8
Status Display and Operation
Condition
Power
on
fl ashes intermittent-
ly (every 8s)
off
LAN on
off
on
fl ashes
off
press briefl y
press long
FRITZ!Powerline 1000E
has electrical power
is on standby
has no electrical power
the LAN port is in use
no LAN cable is connected or the device on the LAN
cable is switched off
is connected with the powerline network and ready for
data exchange
resetting or confi guring security settings
did not detect any compatible powerline devices or
did not detect any devices that use the same network
key
integrating safely into an existing powerline network
reset
9