Bell BICYCLE CHILD CARRIER Manual De Instrucciones página 7

STEP 12
Insert the spacer tube and secure using an 8mm by
58mm hex bolt, an 8mm split lock washer and an
8mm Nylock nut.
Note: Do not completely tighten at this time. This
step will require (2) adjustable wrenches.
ITEM #22
8mm x 58mm 8mm Split Lock
Hex Bolt
STEP 13
Insert the short lower bracket into the slotted end of
the long lower bracket and twist into position. Insert
the 8mm by 30mm round head square neck bolt and
secure it with an 8mm split lock washer and an 8mm
Nylock nut.
ITEM # 24 ITEM #23
8mm Nylock
Washer Nut
STEP 14
Repeat on other side of wheel by inserting the
short lower bracket into the slotted end of the long
lower bracket and twist into position. Insert the
8mm by 30mm round head square neck bolt and
secure it with an 8mm split lock washer and an
8mm Nylock nut.
STEP 15
The child carrier must be in a level position when
installed. Several adjustment holes are provided
in the U-bracket which will enable you to clear all
obstructions and level the carrier. When level, tighten
all of the fasteners securely.