Bell BICYCLE CHILD CARRIER Manual De Instrucciones página 8

STEP 16
Place the plastic thread protectors onto the ends of
the hex bolts.
Note: If you are using the 6mm bolt, use the thread
protector with the number 6 on the inside.
STEP 17
Remove the foot guard, spring guards and the foot
guard fasteners from the plastic sheet.
STEP 18
Install the foot guard by wrapping it over the top of
the right and left seat supports and tucking it under
the front edge of the seat. Secure foot guard to the
bicycle frame by inserting the fasteners through
the slots in the foot guard and around the bicycle
frame. If bicycle has exposed springs, wrap spring
guards around springs.
STEP 19
Lay the seat pad into the carrier and thread the
hook and loop straps through the lower lap belt
holes. Secure the hook and loop straps behind the
seat.