Escalade Sports prince SPORT T8830 Instrucciones De Ensamblaje página 2

1. Read this manual carefully before starting assembly. Read each step completely before beginning each step.
2. Some smaller parts may be shipped inside larger parts. Check inside all parts and cartons before assembling or ordering
parts.
3. To make assembly easier, use the Hardware Identifier on page 3 to identify and sort all fasteners. Check all cartons for
kits. All hardware may not be located in one kit.
4. Do not tighten hardware until instructed to do so. If hardware is tightened too soon, mounting holes may not align and
parts may not easily fit together. Leave locknuts slightly loose until you are instructed to tighten them.
5. Tools required for assembly: Phillips Screwdriver, one 3/8" Wrenches, Two 7/16" Wrenches (Ratchet and 3/8", 7/16" Sockets are
recommended and can be substituted for wrenches), Rubber Mallet or Hammer.
6. An electric screwdriver is helpful in assembly. However, please set at low torque and use caution because you could over-tighten the
and strip the screws out of the wooden table top.
7. Save these instructions and your proof of purchase (receipt) in the event that the manufacturer has to be contacted for
replacement parts.
Please Do Not Return This Product To The Store!
Contact Escalade ® Sports customer service department at:
1-866-873-3528
Phone:
Fax: 1-866-873-3533
E-mail: tabletennis@escaladesports.com
Mailing Address (correspondence only):
Escalade Sports
PO Box 889
Evansville, IN 47706
Prince (tm) is a trademark of Prince Sports, LLC.
© 2015 Prince Sports, LLC.
www.princetennis.com
P R E - A S S E M B L Y T I P S
Toll – Free !
Toll – Free !
Please visit our Website at:
www.escaladesports.com
ON-LINE TROUBLE SHOOTING
ON-LINE PARTS REQUESTS
ADDITIONAL ESCALADE
TECHNICAL ASSISTANCE
FREQUENTLY ASKED QUESTIONS
® SPORTS PRODUCT INFORMATION
2L-4238-01
2015 Escalade Sports