Integrated antenna
Frequency Band: 865 - 868 MHz ATX-W42-A-U04: RS232
Frequency Band: 902 - 928 MHz ATX-W52-A-U04: RS232
ATX / ATX4:
To supply model or to provide V+, V- use only power adaptors with outputs in compliance with ES1 and PS2 (LPS per Annex Q of IEC/UL/EN
62368-1) types.
V+, V- musn't exceed 30 Vdc.
Main power supply:
Consumption:
ATX / ATX4 -POE+:
Use an IEEE 802.3at.2009-compatible PSE (Power Sourcing Equipment).
Main power supply:
If several readers are connected to the PSE, check that each port of the PSE supplies 20W.
Communication:
RS485 (L+ & L-) / RS232 (TD & RD) (SUB D9) / Ethernet (RJ45) / USB C (wedge mode)
Temperature:
-20°C to +50°C / -4°F to +122°F
Protection:
IP66 level
Chip:
EPC1 Gen2 (ISO 18000-63) - 1 to 62 bytes max
I/O:
4 optocoupled inputs and 4 optocoupled outputs
Use multi-conductor shielded twisted pair cable specially made for ATEX environment.
Max length RS485: 3 280 ft / 1000 m at 9600 baud (SYT2 AWG24 recommended)
Max length RS232: 49.21 ft / 15 m (SYT2 AWG24 recommended)
Ethernet:
100m, category 5E
▪ Install the module/reader away from computer transmission cables or from power sources (ex: RJ45, sector...).
The disruptions that they can cause can vary according to their radiation power and their proximity.
▪ Use a filtered and regulated power supply.
▪ Antennas connected to different modules/readers may interfere with each other. Move them away from each other.
▪ A power supply which provides 1 A min under +24Vdc is recommended. If the IN/OUT are powered by the module, use a 2A min under +24Vdc
power supply.
▪ Users must not remain within a range of less than, 34 cm / 13.39 in from an antenna for an extended period of time as per EN50364
applicable to this type of device.
▪ Before any service operation you must de-energize reader.
▪ Do not remove the caps from the unused RF connectors:
Power jack
RJ45
DE9-COM
M12 IN/OUT
USB-C
ATEX & IECEX UHF reader
Installation procedure
ATX-W43-A-U04: RS485
ATX-W44-A-U04: TCP-IP + POE
ATX-W53-A-U04: RS485
ATX-W54-A-U04: TCP-IP+ POE
Range +12 Vdc up to +30 Vdc
Typical: 0.6 A under +24 Vdc
Range +42.5 Vdc to +57 Vdc
© STid - 20 PA des Pradeaux FR13850 Gréasque – NI1145B01 - Page 1 sur 15 - Ed. 02/09/2020
Lecteur UHF ATEX & IECEX
Notice d'installation
Frequency Band: 865 - 868 MHz
+
Frequency Band: 902 - 928 MHz
+
Power Supply Characteristics
Typical: +24 Vdc
Max: 0.8 A under +24 Vdc
Typical: +48 Vdc
Characteristics
Recommended Cables
Recommendations
Connector ATX
ATEX & IECEX UHF lectores
Manual de instalación
External antenna
ATX4-W42-A-U04: RS232
ATX4-W43-A-U04: RS485
ATX4-W44-A-U04: TCP-IP + POE
ATX4-W52-A-U04: RS232
ATX4-W53-A-U04: RS485
ATX4-W54-A-U04: TCP-IP + POE
US
FR
ES
+
+