Dyna-Glo DGA480BSN Manual De Instrucciones página 5

ASSEMBLY INSTRUCTIONS
3. Insert one M6x12 screw (AA) halfway into the
middle rear threaded hole on both the cart left side
panel (D) and cart right side panel (E). Attach
the cart rear panel (F) by sliding the keyholes
in the cart rear panel (F) over the inserted
screws. Slide the cart rear panel (F) down to
meet bottom shelf (A). Secure the cart rear
panel (F) to the bottom shelf (A) with 3 M6x12
screws (AA). Tighten all screws, including the 2
screws in cart side panels (D and E).
Hardware Used
AA
M6 x 12 Screw
4. Insert 2 M6x12 screws (AA) halfway into the top
front threaded holes of both the cart left side
panel (D) and the cart right side panel (E).
Attach the upper door brace (G) by sliding
the cut-outs in the upper door brace (G)
over the 4 screws and tightening all 4
screws.
Hardware Used
AA
M6 x 12 Screw
3
D
x 5
4
AA
x 4
8
AA
F
A
AA
AA
E
G
E
G
D