Panel Description - koban KPF-04 Manual Del Usuario

KPF-04

2.Panel Description

1.Transformer Jaw
This is used to pick up current signal.
To measure AC current, conductor must
be enclosed by the 68 mm diameter jaw.
2.Transformer Trigger
This is used to open the jaw.
3.Function Selector Switch
This is used to select the function user
desired, such as AC/DCV ,ACA, ohm and
continuity.
4. Max/Min Hold Button
This button is used to enable the
maximum or minimum value to be
displayed and updated during measurement.
Press once, minimum value shall be
displayed and updated. press again,
maximum value shall be displayed and
updated. Press & hold the button again
(the third push ),clamp meter return to
normal measurement mode.
5. Peak hold Button
This button is used to enable the Peak value to be displayed and updated during
measurement. Press again clamp meter return to normal measurement mode.
6 .Data Hold &Backlit Button
once this button is pushed,reading shall be held on the LCD. Press again to
release it. Press & hold the button 2 Sec. release backlight is on, again press &
hold the button 2 Sec. release backlight is off.
1
AUTO
POWER
OFF
20A
2A
2
200
mA
6
HOLE
7
MODE
P MAX PEAK
MIN
AC
DC
AT
TRUE RMS AC CLAMP
LEAKAGE CURRENT TESTER
COM
10
EN
1000A
200A
3
Ω
V
OFF
4
MAX
5
PEAK
MIN
WIDE
H INRUSH
50 60Hz
°C °F
V
8
mA
Ω
k
Hz
V
Ω
9
CAT III
600V
5