Unpacking Instructions - Fanimation DRONE FPD6235 Serie Manual Del Usuario

This manual is designed to make it as easy as possible for you
to assemble, install, operate, and maintain your ceiling fan
Tools Needed for Assembly
• One Phillips head screwdriver
(supplied)
• One 1/4˝ flat head screwdriver
(supplied)
• One hex wrench (not supplied)
WARNING
Before assembling your ceiling fan, refer to section on
proper method of wiring your fan (page 10). If you feel you
do not have enough wiring knowledge or experience,
have your fan installed by a licensed electrician.
For your convenience, check-off each step. As each step is completed, place a check mark. This will ensure that all
WARNING
Do not install or use fan if any part is damaged or
missing. This product is designed to use only those
parts supplied with this product and/or any accessories
designated specifically for use with this product by
Fanimation. Substitution of parts or accessories not
designated for use with this product by Fanimation could
result in personal injury or property damage. Contact
your retail store for missing or damaged parts.
1. Check to see that you have received the following
parts:
NOTE: If you are uncertain of part description, refer to
exploded view illustration. (Figure 1, page 17)
Ceiling Bracket Assembly
Wire Tray Assembly
Housing Assembly
• One stepladder
• One wire stripper

Unpacking Instructions

Fan Motor Assembly
4
Materials
Wiring outlet box and box connectors must be of type
required by local code. The minimum wire would be a 3-
conductor (2-wire with ground) of the following size:
Installed Wire Length
Up to 50 ft.
50 - 100 ft.
NOTE: Place the parts from the loose parts bags in a small
container to keep them from being lost. If any parts are missing,
contact your local retailer.
• Ceiling Bracket Assembly
• Fan Motor Assembly
• Wire Tray Assembly
• Housing Assembly
• Lower Blade Plate
• Plastic Cap Assembly
• Blade Set
• Hand Held Remote
• Receiver Unit
Lower Blade Plate
Plastic Cap Assembly
Blade Set
Wire Size A.W.G.
14
12
• Hardware bags:
– Ten #10-32 Serrated Head screws
– Seven #8-32 Washer Head screws
– Blade Plate
– Phillips Screwdriver, 4˝
– Bag Assembly Safety Cable
Receiver Unit
Hand Held Remote
Hardware bags