How To Assemble Your Ceiling Fan - Fanimation DRONE FPD6235 Serie Manual Del Usuario

1. Slide the housing assembly over the motor assembly
shaft. (Figure 1)
2. Remove the three screws from the motor coupler
assembly. Assemble the wire tray assembly to the coupler
using the removed screws and securely tighten all screws.
(Figure 2)
3. Hang the motor assembly from the ceiling bracket
assembly using the hook from the bracket and the cable
from the fan as shown. You can now proceed with the
electrical wiring of your fan. (Figure 3)
4. Attach the safety cable to ceiling support cable. Slide
cable clamp onto safety cable (from fan). Place the end of
cable through the loop of ceiling support cable. Pull as
much cable through loop as possible. Feed end of
cable into clamp hole and firmly tighten screw (Figure 4).
Cut off excess safety cable.

How to Assemble Your Ceiling Fan

Housing Assembly
NOTE: Supply wires
omitted for clarity
Ceiling Bracket
Assembly
NOTE: Supply wires
omitted for clarity
Ceiling Support
Cable
Safety Cable
NOTE: Supply wires
omitted for clarity
9
Motor
Assembly
Figure 1
Wire Tray
Assembly
Figure 2
Wire Tray
Assembly
Figure 3
Motor
Assembly
Figure 4
Housing
Assembly