Botones De Control Y Funcionamiento - EcoxGear EcoXBT Guia Del Usuario

Botones de Control y Funcionamiento

Encendido/Apagado
Pulse el botón una vez para
encender/apagar.
El LED verde se enciende y,
después de 2-4 segundos, la
unidad emite un pitido para
indicar que se ha iniciado y
que está encendida.
Bluetooth
1 Busque y active el
Bluetooth en su
Smartphone/Smartdevice.
2 Pulse el botón una vez
en EcoXBT para activar
el Bluetooth. El LED Azul
parpadeará de manera
rápida para indicar que
está listo para vincularse.
3 Busque "ECOXGEAR"
en su Smartphone para
seleccionar la vinculación
y seleccione "ECOXGEAR"
para vincularlo con EcoXBT.
4 ¡Escoja y reproduzca
su música!
Volumen del Altavoz
Mantenga pulsado ( - )
para reducir el volumen del
altavoz. Mantenga pulsado
( + ) para aumentar el
volumen del altavoz.
NOTA: Establezca su
Smartphone al nivel
máximo del volumen para
conseguir la mejor calidad
de audio.
Sonará 1 pitido breve
cuando se alcance
el volumen máximo
establecido en EcoXBT.
Selección de la Pista
Pulse ( << ) una vez para
seleccionar la pista de audio
anterior. Pulse ( >> ) una vez
para seleccionar la pista de
audio siguiente.
Reproducir Pausar
Responder
Pulse el botón una vez
para pausar y reproducir
una pista de audio y para
responder a llamadas
telefónicas. (Debe estar
vinculado con Bluetooth).
Pulse el botón para
responder a llamadas
entrantes de su Smartphone.
Escuche a su interlocutor
a través de los altavoces
EcoXBT y comuníquese
a través del micrófono
incorporado en la parte
frontal de la unidad.
SAFETY
This product has a limited life span of use and should be replaced when it shows
obvious signs of wear.
Do not modify or remove any original component parts of the speaker. Doing so could
cause damage to the unit allowing water to ingress. A unit with water ingress should
not be charged due to potential risk of fire or shock.
Do not attempt to mount the unit except with the approved ECOXGEAR mounts.
Doing so could cause damage to the unit allowing water to ingress. A unit with water
ingress should not be charged due to potential risk of fire or shock.
Please exercise care and good judgment when using your ECOXGEAR speaker. Audio
levels should be appropriate to your environment, comply with all local regulations,
and always ensure that you can hear and be aware of any potential hazards around you.
You should always
1) Use the ECOXGEAR speaker in accordance with any music or noise rules
and regulations.
2) Use the proper ECOXGEAR mounts if you intend to mount the unit.
3) Properly seal the ECOXGEAR prior and after each use when in humid or water
environments to avoid water damage to the internal components. Salt water / air
is particularly corrosive. Always make sure that the gaskets are sealed when in salt
water environment and the unit properly rinsed off after use.
4) Properly clean the ECOXGEAR and ensure the gaskets have no sand, dirt or water
on them prior to storage or removing the back cover.
5) Store your unit with all caps properly sealed to avoid long term internal moisture
damage inside your unit.
6) Completely dry and clean your ECOXGEAR prior to attempting to charge the unit.
7) Return the ECOXGEAR to Grace Digital if you suspect water ingress into the unit
or if the unit has experienced a severe impact that may have affected the
integrity of the unit to take on water.
You should never
1) Charge your ECOXGEAR if you suspect water has entered the device. Charging a
device with water inside could be potentially hazardous and cause fire or a spark.
2) Use your ECOXGEAR if you have dropped it or thrown it against a hard surface
which may have destroyed the integrity of the speakers, housings or gaskets. In
the event of a severe impact to your unit please return the unit to Grace Digital to
review for potential damage.
3) Open the auxiliary door in a water environment. This could cause water to ingress
into the unit which could potentially be hazardous and cause a fire or a spark.
4) Connect a device to the auxiliary input jack when in a water environment. The
auxiliary jack should only be used in a dry environment.
5) Attempt to fix, repair your ECOXGEAR unit. Please send it back to Grace Digital
for any assessments and repairs.