Alcad STB-020 Manual página 25

As previously indicated, the factory TCP/IP configuration of the unit is:
To access the unit use a PC/MAC with Ethernet card and a RJ-45 cable (CAT -5E or CAT-6)
The IP address of the PC/MAC must be configured with the following range:
(Do not use the address 192.168.10.100 because it is the address of the unit to be configured)
To start the configuration of the unit, open your web browser and type the address:
http://192.168.10.100
The first page of the ALCAD IPTV configuration program will be displayed. Access to this site is protected
by username and password. Hence, once the default key has been changed, the only persons who will
have access to the site will be those who have been provided with a permanent key by the installation
company.
By default, the first time the module is accessed the key is:
26 - STB-020 Web Configuration Manual
IP address: 192.168.10.100
Subnet mask: 255.255.255.0
Default Gateway: 192.168.10.1
192.168.10.2 - 192.168.10.254
Username: alcad
Passwork: alcad
Fig.5 - Initial Screen
ESP
ENG ENG ENG