Working Mode Setting; New Password Setting - SATA 02003 Manual Del Uso

6.2 Working Mode Setting

1 ） If the correct password is entered, the machine will enter the working mode and the window will display the currently
set working mode.
2） Press the " ▲ " or " ▼ " key to select the working mode following the order shown below:
3） After selecting the working mode, press the " ＊ " key for new password setting.

6.3 New Password Setting

1 ） After entering the new password setting mode, the window will display "---". At this time, press " ▲ " or " ▼ " key, and
the hundreds digit will be lighted and the tens and units will be off.
2） Then press the " ▲ " or " ▼ " key to select the hundreds digit. After selecting, press the " ＊ " key to confirm, and
thenselect the tens digit. The method for selecting the tens digit and units digit is the same as that for selecting the
hundreds digit. After selecting the units digit, press the " ＊ " key to confirm, and enter the password for the second
time. The password setting of the second time is the same as that of the first time.
3） If the two passwords you entered do not match, the window will display "Err" , indicating that the password setting is
not successful. The machine will return to the working state and the password remains unchanged.
4） If the two passwords you entered match, the window will display "OK" , indicating that the password setting is
successful. The machine will return to the working state.
22
02003
Table of Working Mode
Working Mode
00
01
02
3
1 2 4
中文
Temperature Range
100℃ -350℃
100℃ -400℃
100℃ -450℃
5 7
6 8
EN DE RU KO PT
00
01
9 0
JA ES
02