Torin BIG RED TR4076 Manual Del Propietário página 10

TO ADD JACK OIL
The hydraulic cylinder assembly contains hydraulic
fluid that must be kept at approximately 80% full at
all times for proper operation. To check the level and
to fill remove oil filler plug.
1. Position the jack on level ground and lower the
saddle.
2. Remove the oil plug.
3. Fill the oil case until oil level to 80% full.
4. Replace oil plug.
5. Perform the Air Purge Procedure.
TO REPLACE JACK OIL
1. Position the jack on level ground and lower the
saddle.
2. Open release valve by turning handle counter-
clockwise (4 full turns).
3. Remove the oil fill plug.
7
10
4. Turn the jack on its side so that old oil will drain
from the oil fill hole.
5. Position the jack on level ground and lower the
saddle.
on level ground and lower the saddle
6. Fill the oil case until oil level to 80% full.
KEEP DIRT AND OTHER MATERIALS CLEAR
WHEN POURING.
7. Replace oil plug.
8. Perform the Air Purge Procedure.