Intended Use; Technical Specifications - Torin BIG RED TR4076 Manual Del Propietário

IMPORTANT
Before You Begin Register This Product.
For future reference, record the model name, model number, date of manufacture and purchase date of this
product. You can find this information on the product.
Model Name
Model Number
Date of Manufacture
Date of Purchase
OWNER / USER RESPONSIBILITY
DO NOT OPERATE OR REPAIR THIS PRODUCT WITHOUT READING THIS MANUAL.
Read and follow the safety instructions. Keep Instructions readily available for operators. Make certain all
operators are properly trained and understand how to safely and correctly operate the product. By proceeding
you agree that you fully understand and comprehend the full contents of this manual. Failure to operate this
product as intended may cause injury or death. The manufacturer is not responsible for any damages or injury
caused by improper use or neglect. Allow product operation only with all parts in place and operating safely.
Use only genuine replacement parts. Service and maintain the product only with authorized or approved
replacement parts; negligence will make the product unsafe for use and will void the warranty. Carefully
inspect the product on a regular basis and perform all maintenance as required. Store these instructions
in a protected dry location. Keep all decals on the product clean and visible. Do not modify and/or use for
any application other than that for which this product was designed. If you have any questions relative to a
particular application, DO NOT use the product until you have first contacted the distributor or manufacturer to
determine if it can or should be performed on the product.
For technical questions please call 1-888-448-6746.

INTENDED USE

This 1/2 Ton Low Profile Transmission Jack for is designed for transmission installation and removal. It
features a 360° handle that offers rotational mobility for hard-to-reach lifting points. Universal mounting head
provides a wide fore and aft tilt range. Manual operated hydraulic system that includes a bypass system to
prevent over-extension and accidental overloading. Low profile design; four heavy-duty steel swivel casters
provide easy maneuvering throughout the shop. Fits most transmissions. This product is tested for reliability
and safety to meet ASME PASE Standards.

TECHNICAL SPECIFICATIONS

Item
Capacity
Lifting Range
Saddle Forward Tilt
Saddle Backward Tilt
Left Saddle Tilt
Right Saddle Tilt
____________________________
____________________________
____________________________
____________________________
TR4076
1000 lbs.
8-1/2 inch ~ 22-1/4 in.
13°
71°
30°
46°
2