SATA 03005 Manual Del Uso página 30

Note
To avoid electric shock or damage to the meter, do not apply a voltage
greater than 600V to the input.
Measuring AC voltage
1. Connect the black test probe to the "COM" jack and the red test probe to
the " " jack (or "
2. Set the function switch to or mV. Tips: The "
measurement and the "m
3. Connect the test probes to both ends of the circuit to be measured.
4. Take readings.
Note
To avoid electric shock or damage to the meter, do not apply a
voltage greater than 600V to the input.
Measuring DC or AC current
1. Connect the black test probe to the "COM" jack and the red test probe to
the" " jack (or "
2. Set the function switch to the "
3. Press the yellow button to select the AC current or DC current
measurement function and the corresponding symbol will appear on the
screen.
4. Disconnect the power to the circuit to be measured, connect the test
probes in series to it, and then turn on its power.
5. Take readings. When measuring the DC current, the polarity of the end
connected to red test probe will also be indicated.
Measuring resistance
1. Connect the black test probe to the "COM" jack and the red test probe to
the " " jack (or "
2. Set the function switch to the "
the resistance measurement function. When the meter is in the diode test
function (the "
" " symbol appears), press the yellow button until the meter is in the
resistance measurement function (the "
03005 / 03007
" jack).
" position for AC-mV measurement.
" jack).
" position.
" jack).
" symbol appears) or the continuity test function (the
-30-
EN DE
" position is used for AC-V
" position. The meter defaults to
" and " " symbols are not
RU KO PT JA ES