Minelab CTX 3030 Guía De Introducción página 5

4
4. Rotate the upper shaft 90° so that the
control panel points upwards.
5. Lock the cam lock by pushing the lever
towards the shaft
PINCH POINTS - CONTROL BOX. Take
care when sliding the control box onto
the chassis and when operating the
control box latch.
Attach Control Box
1. Slide the control box partly onto the
upper shaft. When it reaches half way it
will click into place to hold the control
box while the connectors are fitted.
Attach the coil and control panel cables
to their respective connectors, and firmly
tighten the retaining rings.
2. Slide the control box further along the
upper shaft until it locks into place.
3. Fit the battery pack onto the control box
and close the latches to secure it in place.
4. Fit the headphone module onto the
control box. Use a screwdriver or coin to
gently tighten the bolt taking care not to
damage the thread by over-tightening.
NOTE
The headphone module is NOT waterproof.
Refer to the CTX 3030 Instruction Manual for
further information on using the waterproof
headphones.
Attach Armrest
1. Turn the armrest lock counter-clockwise
until it is fully open.
2. Slide the armrest onto the rail on top of
the chassis. Ensure that the sloping sides
of the armrest face toward the control
panel.
3. Hold the detector as if detecting and
slide the armrest along the rail until it is
positioned just below your elbow.
4. Remove your arm from the armrest and
turn the armrest lock clockwise to lock it
into position.
Adjust Armrest Strap
1. Loosen the armrest strap by lifting the top
edge.
2. Tighten the strap until your arm is secure
in the armrest, and fasten.
NOTE
To fit a smaller arm, the strap can be fitted
upside down and passed through the
armrest three times.
Recharge Li-Ion Battery Pack with
BC 10 Battery Charger
1. Place the Li-Ion Battery Pack into the
charger unit, ensuring that the pins line
up.
2. Insert the plug pack (or car charger)
connector into the socket on the charger
unit.
3. Plug the other end of the cable into
the wall (or car socket) and turn on the
switch. Leave the unit to recharge.
The green indicator light will stop flashing
when the battery is fully charged (up to
4 hours).
5