Operation; Care And Cleaning - Everbilt SLT370 Guía De Uso Y Cuidado

Operation

Plug the pump power cord plug into a 115V power outlet. Check the pump by filling the sump pit with water and observe the pump's
operation through one complete cycle. Make sure the pump cannot move in the sump pit and the float switch moves freely up and down.
When the float switch moves up to the pump "On" position, the pump will start operating. When the water lowers to a certain level, the float
switch will turn off the pump.
WARNING: Do not handle the pump or pump motor with
wet hands or when standing on a wet or damp surface, or in
water.
NOTE: Place upright on a solid base.

Care and Cleaning

CAUTION: Never use the power cord to lift the pump. To avoid skin burns, unplug the pump and allow time for it to cool
after periods of extended use.
Do
Periodically unplug the pump, making certain your hands are

dry, and you are not standing in water. When the power is
disconnected, inspect the pump inlets and remove all debris,
then plug pump back into the grounded (GFCI) outlet.
To clean a pump clogged with debris:
Unplug the pump from electrical power.

Unscrew the stainless screws (5), and remove the seal plate (4).

Use a flathead screwdriver to hold the shaft (1), then turn the

impeller counterclockwise to release the impeller (2).
Remove debris from around the shaft and on/under the impeller.

Reassemble the pump.

CAUTION: Do not run the pump dry. Operating the pump
without water will cause damage to the seals and will cause
the pump to fail, thereby voiding the pump's warranty.
Do Not
Disassemble the motor housing. This motor has NO

repairable internal parts, and disassembly may cause
leakage or dangerous electrical wiring issues.
Lift up the pump by the power cord.

8