Kohler K–2449 Manual Del Usuairo página 5

Washer
Lock Washer
Bolt
Leg
Pin
Bolt
Knob
2. Install the Legs
Remove the drawer from the lower vanity section.
Position the two leg assemblies on each side of the drawer
assembly with the pins facing each other.
Slide one set of pins into the back rail (flat). Repeat with the other
side.
Slide one set of pins into the front rail (curved). Repeat with the
other side.
Firmly push the front and back rail down.
Carefully slide the drawer assembly up until the bolt holes in the
drawer and legs are aligned.
Slide a lock washer and washer onto each bolt.
Thread the bolts into the legs.
Firmly tighten the bolts using the supplied hex wrench.
Insert the bolt through the front of the drawer from inside the
drawer and thread the knob onto the bolt.
Tighten securely.
Kohler Co. 5 1061207-2-A