Whittier Wood Furniture 747Wa Instrucciones De Montaje página 10

W x 26
Da
X x 2
Y x 2
Z x 2
14. With the unit laying face-down on a clean
protected surface, measure from top
left corner to bottom right corner
and from bottom left corner to top right corner
If the line
If line is longer, tap the bottom of the Right Side Panel (Da). See Figure 14a.
Face the notches toward the top and attach the Back (L) to the unit using #6 x 5/8" Philtruss
Screws (W). Make sure the bottom edge of the back is flush with the bottom edge of the bottom
shelf and equal distance from the sides.
Tap Tack Glides (X) into the bottom of each Back Leg (K). Thread the Adjustable Glides (Y) into
the Plastic Inserts (Z) and tap them into the holes in the bottom of the Front Legs (H & J).
Fig. 15
15. Slide the Top Facing (M) onto the front of the unit aligning the five Rafix Bolts (R) into the five
Rafix Cams (Q). Tighten the cams.
Page 10 — 747Wa — 06/11
Fig. 14a
is longer, tap the bottom of the Left Side (Ca) until measurements are equal.
Q
Q
R
Ca
W
X
Z
Y
. These measurements should be equal.
Q
Q
R
R
W
L
Fig. 14b
Q
R
R
M
Y
Z
W
X
Z
Y
Q
x 5